Simple script to finish after going through wp-file

[spawni]

hmm..if i want to run a wp-file only once - then I have to put a piece of code to end the script (like in your malatina code but that one is a little to complicated cause there is a multi-account-changing-script).
Oterhwise the bot will run to the first wp? (Haven´t tested yet - not enough time).

Maybe you can give me a tipp?

btw.. happy holidays and merry xmas

[lisa]

A normal Wp will go through the waypoints until the last and then start agaon from the first.

so if you have 15 waypoints and #1 is closest to character when the WP is started it will do
1 -> 15 -> 1 -> 15 -> 1 -> 15
and continue on forever.

if # 6 is closest to character at startup then it does
6 -> 15 -> 1 -> 15 -> 1 -> 15
and continue on forever.

So if you want it to do another WP after it reaches #15 then add in code, something like this

Code: Select all

<!-- # 15 --><waypoint x="-13658" z="40641" y="709">	
loadPaths("WPfilename")
</waypoint>

So when it reaches waypoint #15 it will start the WPfilename.xml

[rock5]

If you are simply asking, how to stop a waypoint file, then I would use

Code: Select all

error("Waypoint file finished.")

in the last waypoint.

[kuripot]

how about if i want to use #1-#15 when finish then #15-1?

[lisa]

just change the direction it does the waypoints in.


--=== to do the waypoints in reverse
--=== so at waypoint #15 do

Code: Select all

__WPL:setDirection(WPT_BACKWARD);

--=== to make it go in order again
--=== at waypoint #1 make sure to change it to forward

Code: Select all

__WPL:setDirection(WPT_FORWARD);